Photos: James Chappel
Kayak tie-down loops made from fabric webbing lie on a wooden floor.

I can’t tell you how many times I have seen people transporting kayaks without the bow and stern tied down.  They only have two straps over the kayak.  I will admit I have been guilty of this in the past, due mainly to not having any anchor points for the bow and stern straps.  The only anchor points I had on my car was the frame underneath the front and rear bumper.  Getting to these spots was a hassle and having the strap right up against the car would scratch the paint.

I decided there had to be a simple way to add some sort of removable anchor point for the bow and stern straps.  Searching the internet revealed some pricey options.  Companies were charging over 20 dollars for what was essentially a piece of webbing with a grommet.  I decided to come up with a cheap alternative.  With about 10 minutes of your time and very little money anyone can make their own anchor point loops. I actually had all the needed materials so this project cost me nothing.  Even if you have to buy some or all of the materials the cost is extremely low.

These DIY Hood Loops aren't permanent and won't damage your car or truck.

I decided to make two different style loops for my needs.  The first was a loop secured to a piece of small diameter PVC pipe that can be easily closed in your trunk or hood leaving the loop sticking out. I decided to use this style for my trunk.

First you need to find a small diameter piece of PVC pipe.  I used the gray pipe used for running electrical wire.  I drilled a hole through the pipe which will be used for running a bolt.  I then found a unused tie down strap and cut a small section off.  I made two holes in the ends of the piece of strapping which will be used to pass a bolt through.

DIY Hood Loops are easy and cheap to make.

I found a bolt long enough to run through the strap and PVC.  I secured the bolt with washers and a nut.  This anchor point can now be shut inside of your trunk leaving a loop sticking out which can be used for your bow/stern tie downs.  You can use the loop in any location along your trunk and you can use as many as you need.  You can also use this under the hood of your car if you have enough space for it to fit and still be able to close your trunk.

DIY Hood Loops will keep your boat from sliding around on your roof.

I do not have enough space under my hood to do this so I decided to use another style for making a tie down loop for under my hood.  The first thing to do was find a unused hole in the frame of your car underneath your hood.  The hole needs to be somewhat close to the gap between your hood and the body of your car.  Most cars will have one that you will be able to use.  I have had no issue finding a unused hole in the frame of every car I have owned since I started kayaking.

These DIY Hood Loops can be stored in your trunk until you're ready to carry your kayak.

Now get another piece of strap or webbing and make two holes in the ends for running a bolt.  Find a bolt long enough to run through the strap and through the hole in the frame of your car.  Attach a washer on both ends and tighten everything down with a nut.  This loop cap now be pulled out of the gap between your hood and body of your car and can also tucked back under the hood when not being used.

It is important to check on all the components regularly and make sure the bolts are tight and the straps are not ripped or frayed.  I never pull the bow and stern straps overly tight.  I simply tighten until there is no more slack in the straps.  The job of these straps is to keep the kayak from swaying around while driving and provide insurance incase of a rack failure.  The most important thing you can do is regularly checking your rack for any problems.

Make your own DIY Hood Loops in a few minutes for every car you drive.

Want another DIY project from James Chappel? Check out his step-by-step DIY Light Pole build tips.

LEAVE A REPLY

Please enter your comment!
Please enter your name here